-
Posts
2584 -
Joined
-
Last visited
-
Days Won
114
Reputation Activity
-
Bassboy3313 reacted to P_Roloff in 2011 328i Longroof - The Saga Continues
I’ve just been putting up with the dreaded musty smell from the HVAC vents in this car since the summertime and it hasn’t been getting any better, so I finally decided to do something about it. I’m pretty sure the issue came about when I turned on the recirc mode for a week or two when it was really hot to try to get slightly cooler temps out of it; I’ve now read that recirc mode should be used sparingly and you should walkways turn off the ac and run the fan for a few minutes before shutdown to air it all out.
After some product research, I decided the Nextzett Klima Cleaner would be my best bet:
I went with the method of removing the blower motor and spraying directly onto the evaporator; my first attempt I missed with the hose and didn’t get it all the way there. The second try, I got the hose sufficiently far over and hit the evaporator square; it foamed up nicely and drained thru the evap drain hoses along the trans tunnel.
I waited 20ish minutes, put the blower back in (so much easier than the e30), and ran the fan on high for 10ish minutes to dry it all out. I’ll report back in a week or two on the results!
I also discovered a 12V power plug on the panel under/behind the glovebox door that I never knew I had, so that’s a win! I might need to enlist @Bassboy3313 to make me another of those printed inductive charger pads and run the power to it from this plug.
-
Bassboy3313 got a reaction from Jdesign in Official-look-what-i-found-thread (craigslist, other-forums, etc)
Ultimate BMW???
https://www.facebook.com/marketplace/item/2008913639484566/?mibextid=dXMIcH
-
Bassboy3313 got a reaction from m42b32 in Official-look-what-i-found-thread (craigslist, other-forums, etc)
Ultimate BMW???
https://www.facebook.com/marketplace/item/2008913639484566/?mibextid=dXMIcH
-
Bassboy3313 got a reaction from Jdesign in BMW ProTool App
Sounds good to me. We'll figure out a day.
-
Bassboy3313 got a reaction from m42b32 in BMW ProTool App
Sounds good to me. We'll figure out a day.
-
Bassboy3313 got a reaction from Jdesign in Z3 Coupe content
Rear hatch panel and one door panel done. One door panel to go. The door panels are a pain in the ass!!!! Far from perfect, but good enough for me.
-
Bassboy3313 got a reaction from Rekpoint in Z3 Coupe content
Rear hatch panel and one door panel done. One door panel to go. The door panels are a pain in the ass!!!! Far from perfect, but good enough for me.
-
-
Bassboy3313 got a reaction from Boris3 in Z3 Coupe content
Rear hatch panel and one door panel done. One door panel to go. The door panels are a pain in the ass!!!! Far from perfect, but good enough for me.
-
Bassboy3313 got a reaction from timmer in Free E30 Hood
If @Boris3 doesn't take it, I'll probably grab it. Always like making livery wall art out of BMW hoods when I can.
-
-
Bassboy3313 got a reaction from KaiserRolls in Z3 Coupe content
Just been enjoying the car and driving it a lot lately. Not too much more has been done unfortunately. Still working on custom interior work too.
-
Bassboy3313 got a reaction from Rekpoint in Z3 Coupe content
Just been enjoying the car and driving it a lot lately. Not too much more has been done unfortunately. Still working on custom interior work too.
-
Bassboy3313 got a reaction from YoungCR in Z3 Coupe content
Just been enjoying the car and driving it a lot lately. Not too much more has been done unfortunately. Still working on custom interior work too.
-
Bassboy3313 got a reaction from P_Roloff in Z3 Coupe content
Just been enjoying the car and driving it a lot lately. Not too much more has been done unfortunately. Still working on custom interior work too.
-
Bassboy3313 got a reaction from Jdesign in Z3 Coupe content
Just been enjoying the car and driving it a lot lately. Not too much more has been done unfortunately. Still working on custom interior work too.
-
Bassboy3313 reacted to KaiserRolls in ‘91 E30
It is stainless steel, that is a grease zerk
https://leogranderacing.com/products/greasable-stainless-steel-clutch-fork-pivot-pin
-
Bassboy3313 got a reaction from m42b32 in Finally Joined the Longroof Club
Wish the touring was coming home with me, but I'm sure it's still going to a good home. Congrats on the bronco too!
-
Bassboy3313 reacted to m42b32 in Finally Joined the Longroof Club
119.2k
Finally got around to doing the brakes over the last couple months as they were properly worn out. I built up a sandblasting cabinet over the summer and stripped/painted the 335i calipers and caliper brackets and rebuilt with new seals/boots/guides/hardware. I also painted them gold because I wanted a little color and liked the look of the oem BMW performance brake kit that's painted in phoenix yellow. I installed everything along with new rotors/pads/outer rubber lines and a fluid flush. Because of the larger calipers I coded in the performance brake option to the vehicle order that adjusts the bias/pedal feel/abs/etc. to match the larger brakes. Overall a massive improvement, should've done it way sooner.
I also bought a new daily about a month ago. I've had a weird itch to get into something manual/4x4 for a while and more recently my wife and I decided we needed something a bit bigger for road trips. Decided it was time to scratch that itch and after a lot of searching I got a bit lucky (given the current car market) and ended up picking up a manual '22 Bronco Badlands out in Seattle. I've been really enjoying it so far.
The sad news is that the Bronco will be replacing the wagon so unfortunately that's where my time in the Longroof club ends.... or so I thought. After nearly 5 years and 50k miles of trouble free driving for me it decided to do this on a test drive with a potential new owner lol.
Sooo I got it towed back home and did a fairly complete cooling system overhaul last weekend. New radiator, expansion tank, upper and lower radiator hoses, replaced the hose that split with the updated version, water pump, thermostat, both of the large diameter hoses that connect to the water pump, replaced the plastic 'mickey mouse' flange on the head with an aluminum version and new hose to that too, and a fresh fill of the good ol' BMW blue coolant. Also replaced every o-ring on the hose connections I disconnected but didn't replace with new peroxide-cured EPDM o-rings. With that it's running great again and it'll be headed to its new home this week. I'm definitely going to miss this one.
-
Bassboy3313 got a reaction from P_Roloff in I'm now in the E90 club
Alright, alright. I forgot to take pics of the finished bracket, but here is one of the test print before doing it for real in black ABS.
I then bought the DIY wireless phone charger kit from ECS Tuning to make it an easy install.
https://www.ecstuning.com/b-inbay-parts/wireless-charging-retrofit-kit-3-coil/240000-10-1~iby/
And here it is installed.
-
-
-
Bassboy3313 got a reaction from m42b32 in I'm now in the E90 club
Alright, alright. I forgot to take pics of the finished bracket, but here is one of the test print before doing it for real in black ABS.
I then bought the DIY wireless phone charger kit from ECS Tuning to make it an easy install.
https://www.ecstuning.com/b-inbay-parts/wireless-charging-retrofit-kit-3-coil/240000-10-1~iby/
And here it is installed.
-
Bassboy3313 got a reaction from patsbimmer1 in I'm now in the E90 club
Alright, alright. I forgot to take pics of the finished bracket, but here is one of the test print before doing it for real in black ABS.
I then bought the DIY wireless phone charger kit from ECS Tuning to make it an easy install.
https://www.ecstuning.com/b-inbay-parts/wireless-charging-retrofit-kit-3-coil/240000-10-1~iby/
And here it is installed.
-
Bassboy3313 got a reaction from Jdesign in I'm now in the E90 club
Alright, alright. I forgot to take pics of the finished bracket, but here is one of the test print before doing it for real in black ABS.
I then bought the DIY wireless phone charger kit from ECS Tuning to make it an easy install.
https://www.ecstuning.com/b-inbay-parts/wireless-charging-retrofit-kit-3-coil/240000-10-1~iby/
And here it is installed.